Find codes for each device and brand using this website. Search codes by type in the brand name of your device; in the search box, at the top right of the display window. Note the set-up codes said for your device; [whether it is 4 digit, 3 digit or so], and then proceed.
RCA universal remote control set-up procedure1.1Press and “HOLD” CODE SEARCH.
2. Press and release the TV or VCR button you want to set up. When the selected device button blinks go to the next step.
3. Next enter the 3 digit code from the TV, VCR or Cable Box remote code list.
4. Release CODE SEARCH.
5. With the device on press VOLUME UP to see if the tv responds.
If the TV or other does not respond then simply repeat steps 1-5 using another code number from the lists in the website.
To Program a DISH NETWORK Remote Control.
1. While at the device location, point your remote at the device. Press and hold the device mode button on your remote. All four mode buttons should light up.
2. Press the receiver POWER button on your DISH remote. The device button should light up.
3. Press the UP or DOWN arrow on the remote (about one press per second). During the scan, the mode light will remain lit when you are not pressing the up or down arrow, but will go out each time the arrow is pressed. Stop as soon as the device turns off, and proceed to step 5. This process may take several minutes. The TV should turn off.
If the scan has cycled through all available codes, the mode light will blink rapidly for two seconds, and will light up only when you press the up or down arrow. This may take approximately 5 minutes. If the scan fails to produce a code that will control the device, advise the customer that Dish does not currently support the equipment.
5. Press the POUND (#) button. The device Mode button should flash 3 times.
5. Press the POWER button on your remote to turn the device on. If this does not work, return to step 1.
The device should turn on and respond to remote commands.
How to Program any Philips Universal Remote Control.
1. Turn on the device you wish to program to operate with the Philips Universal Remote Control.
2. Hold down the “Code Search” button on the remote control. Release the button after the red indicator light blinks.
3. Press the device button, such as “TV” “CLB” “VCR” or “SAT” This will make the indicator light blink off and then back on.
4.Keep pressing the “CHAN +” button until the device changes channels. When the TV changes channels again, stop.
5.Press the “Mute” button to save the code in memory.
