To program the ID code for a particular brand
- Switch on the TV you wish to control with the remote control Press and hold both the TV and OK keys.
- Release both the TV mode key and OK key.
- All of the mode keys will give 2 short blinks to indicate setup mode.
- Look out for the 4-digit code of your TV set in TV & DVD Setup Code List and enter them by pressing the number keys on your remote control
- After the fourth key has been entered, the TV mode LED will blink 3 times to indicate a successful configuration.
- If an invalid code has been entered the, ALL the mode LEDs will flash once to indicate unsuccessful configuration.
- If you are unsuccessful in the configuration repeat the steps to configure the remote control again.
- Should you wish to program a different TV device to this remote control, repeat Steps 1-6 again with the selected TV.
To automatically search for your TV device.
- Switch on the TV you wish to control with the remote control
- Press and hold both the TV and OK keys.
- Release both the TV mode key and OK key.
- All of the mode keys will give 2 short blinks to indicate successful entry into the current setup.
- Enter the auto-search setup code 9 – 2 – 2
- After the third key has been released, the TV mode LED will give 2 short blinks to indicate it is in auto-search mode.
- Press and hold the PLAY key to activate the auto search. The remote control will now automatically go through its database of TV codes to search for a relevant TV device.
- If the selected TV device responds by turning off the power, this means that auto-search has found the correct code for your TV device. Immediately release the PLAY key and press the OK key.
- After the OK key has been released, the TV mode LED will blink 3 times to indicate successful configuration.
- To exit the auto search mode without configuring the TV device, Press the EXIT key. After the EXIT key has been released, the TV mode LED will blink 3 times to indicate it has exited auto-search mode.
To program the ID code for a particular brand of DVD.
- Switch on the DVD player you wish to control with the remote control.
- Press and hold both the DVD and OK keys.
- Release both the DVD mode key and OK key.
- All of the mode keys will give 2 short blinks to indicate setup mode.
- Look out for the 4-digit code of your DVD player in TV & DVD Setup Code List and enter them by pressing the number keys on your remote control.
- After the fourth key has been entered, the DVD mode LED will blink 3 times to indicate a successful configuration.
- If an invalid code has been entered, ALL the mode LEDs will flash once to indicate unsuccessful configuration.
- If you are unsuccessful in the configuration repeat the steps to configure the remote control again.
- Should you wish to program a different DVD player to this remote control, repeat Steps 1-6 with the selected DVD player.
To automatically search for your DVD Player
- Switch on the DVD you wish to control with the remote control.
- Press and hold both the DVD and OK keys.
- Release both the DVD mode key and OK key.
- All of the mode keys will give 2 short blinks to indicate successful entry into the current setup.
- Enter the auto-search setup code 9 – 2 – 2
- After the third key has been released, the DVD mode LED will give 2 short blinks to indicate it is in auto-search mode.
- Press and hold the PLAY key to start the auto-search mode.
- The remote control will now automatically go through its database of DVD codes to search for a relevant DVD player.
- If the selected DVD device responds by turning off the power, this means that auto-search has found the correct code for your DVD device. Immediately release the PLAY key and press the OK key.
- After the OK key has been released, the DVD mode LED will blink 3 times to indicate successful configuration.
- To exit without configuring the DVD device, Press the EXIT key. After the EXIT key has been released, the DVD mode LED will blink 3 times to indicate it has excited auto-search mode.
