Direct Code Entry
- Turn on the device (for example, DVD player) and, if needed, load media (for example, a DVD).
- Press the device key, on the remote, that you wish to program (DVD, STB, or AUX).
- Press and hold SET until the red LED blinks twice, then release.
- Enter the first five-digit code for the device and brand that you wish to program. The LED blinks once as each digit is entered. If the code is valid, the LED blinks twice. [NOTE: If the LED does not blink twice, repeat steps 2 to 4 and try entering the code again.]
- Aim the remote at the device and press POWER. The device should turn off. If it does not, repeat steps 3–5, trying each code for your brand until you find one that works. If you cannot find a code that works,
- Repeat steps 1–5 for other devices you want to control.
Code Search Method
If your device doesn't respond to the remote after trying
all codes listed for your brand, or if your brand is not listed, try searching
for your code:- Turn the device you wish to control on.
- Press the desired device key once.
- Press and hold SET until the red LED blinks twice, then release.
- Enter 9 9 1. The LED blinks twice.
- Press the device group number for your device type
- Aim the remote at the device and press POWER. The remote sends IR codes from its library to the selected device, starting with the most popular code first. If the device responds, go to step 8.
- If device doesn't respond, press CH + and the remote will test the next code for that device type. Continue to press CH + until the device turns off. [NOTE: Press CH – to try the previous code.]
- Now that you've found the correct code, press SET to save the code that worked for your device. The LED blinks twice to indicate that the code has been saved. To search for other device codes, repeat steps 1 – 8.
