BOSE - CINEMATE _ UNIVERSAL REMOTE CONTROL PROGRAMMING INSTRUCTIONS

SETTING UP THE REMOTE TO CONTROL OTHER SOURCES.

• The universal remote control provided with your CineMate™ speaker system can be programmed to control your TV, cable/satellite box, VCR, DVD player, and Digital Video Recorder (DVR) such as TiVo brands or ReplayTV brands. With the CineMate universal remote, you can enjoy the convenience of using only one remote control for all your home theater equipment.
• In order to control your TV and other sources with the universal remote control, you must program the remote with a five-digit device code for each source.

To find the code list, check this link.

TO CONTROL TV

The steps below show how to set up the remote to control your TV. To set up the remote to control other sources, you will need to follow the same procedure, using the appropriate device code and source button for each source.

1. Locate the TV section in the CineMate Universal Remote Device Codes list by the above linked site
2. Locate the five-digit device code(s) for your brand of TV and start with the first one.
3. Press and hold Setup on the remote until all five source buttons light up.
4. Press the TV source button. Only the TV source button will remain lit.
5. On the remote keypad, enter the first device code for your brand of TV.
6. Check that the TV source button blinks twice and turns off after the code is entered.
7. Point the remote at your TV and press TV On-Off. If your TV does not respond, go back to Step 1 and try another code.

Follow the same procedure for each of your other sources, using the appropriate device code and source button for each source.

Note: During programming, the five source buttons will flash rapidly three times if you press an invalid key or enter an unavailable device code. If this happens, go back to Step 1 and start over.

USING THE REMOTE TO WATCH TV

• Press On-Off to turn on the CineMate™ speaker system. The green LED on the front of the Interface module will light.
• Press TV On-Off to turn on your TV.
• Press the TV source button. The button will flash to indicate that the remote control is in TV mode.